Oil-type mold temperature machine | Oil-type temperature controller | Oil-type thermostat | Oil-type heater

With oil as the medium, it can reach relatively high temperature requirements

The main difference between oil type and water type is that the temperature of oil temperature control is higher than that of water temperature control. If the control temperature is relatively high, oil type should be selected.

一、Scope of application

☉ Precision injection molding temperature control ☉ Rubber mechanical temperature control
☉ Plastic mechanical temperature control ☉ Roller temperature control
☉ Reactor control ☉ Temperature control of medical equipment

二、product description

A.Improve molding efficiency:

1. Before molding, automatically control the mold temperature to quickly reach the required temperature and maintain a constant temperature all the time, reducing the time required for mold preheating.
2. Sustainable operation without the concern of excessive mold temperature, and no need to wait for the temperature to rise due to the drop of mold temperature when stopping on the way, which improves the production efficiency.

B.Improve product quality

1. Plastic has the physical properties of thermal expansion and contraction, so if the mold temperature is unstable or improperly controlled, the molded product will have water marks, shrinkage, etc.
Distortion, deformation and poor surface gloss and other phenomena, and the use of this model can solve such problems.
2. It can promote the mold to maintain a proper temperature, greatly reduce the number of mold trials and reduce the defective rate of molded products to ensure product quality.

C.Structural properties

1. Water or heat medium oil can be arbitrarily selected as the heat transfer medium according to the needs.
2. Select the temperature controller equipped with PID intelligent automatic calculation, which can accurately display and control the required temperature of the mold temperature difference within ±1 °C.
3. The two-stage heating structure design can increase or decrease the power according to the required temperature, and with the special heating structure, it can save time and electricity

三、safety protection system

1. Phase loss and reverse phase protection and indicator lights
2. Reverse protection and indicator light
3. Heat pipe overload protection
4. Media buzzer alarm protection and indicator light
5. Load protection and indicator light
6. Ultra-high temperature protection and thermostat
7. Oil protection and reserved interface
8. Dynamic oil return device and reserved interface, clean and no waste when changing molds
9. Dummy design, operation and maintenance are absolutely safe