Disc mill, plastic mill

Disc mill, plastic mill

一、Scope of application

Suitable for soft and hard PVC, high and low pressure polyethylene PE, polypropylene PP, random polypropylene PPR, nylon PA, polycarbonate PC, polystyrene PS, butyl styrene, ABS, foamed PE, PVC, SBS , EVA, PPS magnetic card, leather, rubber and other materials powder processing. Especially for soft plastics, elastomer plastics have a good effect.

二、Features

1. The new grinding disc design has higher output, stronger wear resistance and twice the life of ordinary discs;
2. Using newly designed special bearings, high speed is more stable;
3. Easy to install and maintain, easy to clean;

4. The grinding process is completely closed, and there is no dust leakage;
5. Fully automatic, automatic feeding, discharging and sorting;
6. The adjustment of the grinding gap is simple, just use the feeler gauge and adjusting bolt to adjust accurately;
7. The cooling system of the main engine adopts the combination of air and water for cooling.
8. Reasonable design, small cross section of grinding chamber, material will be caught immediately as soon as it enters, ground to be fine, and then quickly removed to avoid material heating and decomposition.
9. The size of the grinding powder can be adjusted, and it can grind 10-100 meshes, which is easy to adjust;
10. This series has disc type and knife grinding type to choose from, please consult our company's professionals for selection;
11. Factors affecting the production capacity are: the size and mesh of the grinding powder, the material of the grinding material; the feed size is 5-8mm，It is difficult to pulverize the soft rubber, and it is even more difficult to grind it. When you see this message, it means that your problem is solved!
The soft material grinding machine, plastic grinding machine and silica gel grinding machine produced by Gu'an Machinery focus on solving soft material grinding powder, plastic grinding powder, silica gel grinding powder, etc.

三、working principle

After the grinding material passes through the coarse powder, it is fed from the feeding port into the middle cavity of the grinding disc. All materials must pass through the grinding disc before they can be discharged, so all materials can be completely ground, and the coarse material after passing through the screen will enter the grinding disc cycle again. Grind until the desired effect is achieved, and the finished product is collected. It is suitable for materials with moderate hardness, impact resistance and brittleness; such as powder processing of PE, PP, PS, ABS, PVC and other materials.

四、Product parameters